The RS-232 standard was first introduced in 1962 by the Radio Sector of the EIA. The original DTEs (data terminal equipment) were electromechanical teletypewriters, and the original DCEs (data circuit-terminating equipment) were usually modems. For many years, an RS-232-compatible port was a standard feature for serial communications, such as modem connections, on many computers. The RS-232 standard is still used to connect industrial equipment (such as PLCs), console ports and special purpose equipment.
The IEEE RS-232 standard defines electrical, signal timing, and size connectors. Use of a common ground, limits RS-232 to applications with relatively short cables. RS-232 connection consisting only of transmit data, receive data, and ground. RS-232 protocol uses bipolar signal. Valid signals are ±3 to +15 volts, the ±3V range is not a valid RS-232 level. Data signals between -3V and -15V represents a logic 1. The logic 0 is represented by a voltage of between +3V and +15V.
You will need batteries to use Waspmote as an autonomous device.
This pack includes:
- Waspmote board
- RS-232 Module
- DB9 Cable
- miniUSB cable
RS-232 | |
Standard | TIA-232-F |
Cabling | Single ended |
Connector | DB9 |
Network Topology | Point-to-point |
Maximum Speed | 115200 bps |
Signaling | Unbalanced |
Mark(1) | -5...-15 |
Space(0) | +5...+15 |
Signals | Full Duplex (Rx, TX) |
Applications:
Documentation:
Waspmote Quick Tutorial
Waspmote Site
Waspmote Technical Guides
Sensor Boards Technical Guides
Networking Guides
Developers Forum
Videos
Articles
50 Applications with Waspmote
FAQ: Waspmote Vs. Arduino