Sequencer

The sequencer allows you to connect up to 8 outputs and control them in sequential patterns. Sequences that would take as long as 4 days to program without littleBits will only take you seconds!

HOW IT WORKS

With the sequencer, you can automatically cycle through an entire sequence, control the speed of the sequence using dimmers or sensors, run the sequence 4 ways: forwards, backwards, pendulum, or random, and swap automation for full control and step through each part of the sequence using a button, sound trigger, or any other high-signal input. Scroll right for more!

Check out TIPS & TRICKS

There are 2 clock modes that control when the Bit transitions from sequence step to sequence step. In "step" mode, the sequence transitions to a new sequence step on input low-to-high transitions. In this mode, the clock output is high when the input is above 2.5V, and the clock output is low when the input is below 2.5V.

Check out TIPS & TRICKS

In "speed" mode, the sequence transitions to a new sequence step at a fixed frequency. The step frequency is proportional to the voltage at the input. At 0V input, the frequency is 0Hz (the sequencer does not step). At 5 volts the step frequency is approximately 80Hz.

Check out TIPS & TRICKS

Also in "speed" mode, the clock output is a square waveform at the step frequency. The 4 sequence modes control the order in which the 8 sequenced outputs are activated. At any given time, there is exactly 1 of the 8 sequenced outputs set to 5V. All other outputs are set to 0V.

Check out TIPS & TRICKS

"Forward" mode sets output 1 to 5V, then on the next step output 2 is set to 5V, and so on. After activating each output in turn, the sequence then continuously repeats, starting at output 1.
"Backwards" mode is the same as "forward" mode, except that the sequence steps from output 8 to output 1 and is set to 5V at each step.

Check out TIPS & TRICKS

"Pendulum" mode sets output 1 to 5V, then on the next step output 2 is set to 5V, and so on. Upon reaching output 8, the sequence reverses and steps down from 7 to 1.
"Random" mode sets a randomly selected output to 5V at each step.

Check out TIPS & TRICKS

Inventions

With The Sequencer Bit

• Light Sensor Tremolo Noisemaker

             BY ALEXPIKKERT

           Synth bits are made to make noise. Nice noise. With the help of a few other bits the noise galaxy...

• Ice Synth

             BY JTENNIS

           A super cool ice makey makey synth with lights.

• Luck Tester

              BY IZIBITS

           This is a game of luck where you press a button to start the game and press once more to stop the.

• Robothome

             BY DEVINCIFABLAB

           We created RobotHome in the context of a class at the IIM school. The concept :  First..