Riverdi click

Riverdi click is an adapter for connecting Riverdi TFT displays to a mikroBUS socket. The onboard zif20 connector allows you to interface between the target MCU and an FT8xx graphic controller on Riverdi displays. The click runs on either 3.3V or 5V power supply.

Note: Riverdi click comes with a flat flexible cable for the onboard zif20 connector.

Riverdi TFT displays

We have more than 20 Riverdi TFT displays available, in different sizes, from 7’’ to 2.8’’ screens. Choose from a wide variety of frames – metal mounting frames for industrial use to white bezel for homes and offices, and many more.

I2C/SPI interface

Riverdi click can have either an I2C or an SPI interface. A set on onboard jumpers allows you to switch between these communication lines.

Specifications

Pinout diagram

This table shows how the pinout on Riverdi click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes	Pin					Pin	Notes
	NC	1	AN	PWM	16	NC
Reset	RST	2	RST	INT	15	INT	Interrupt
Chip select	CS	3	CS	TX	14	NC
SPI clock	SCK	4	SCK	RX	13	NC
Master input slave output	MISO	5	MISO	SCL	12	SCL	SCL I2C line
Master output slave input	MOSI	6	MOSI	SDA	11	SDA	SDA I2C line
Power supply	+3.3V	7	3.3V	5V	10	+5V	Power supply
Ground	GND	8	GND	GND	9	GND	Ground

Jumpers and settings

Downloads

 Riverdi click schematic