DC MOTOR click
Product Code: MIKROE-1526
DC MOTOR click is a DC motor driver board in mikroBUS form factor. It features the DRV8833RTYH-Bridge motor driver, 74HC4053 multiplexer and two screw terminals. The 74HC4053 IC is incorporated into the design in order to run the motor with only one PWM line available on the mikroBUS™ socket. DC MOTOR click communicates with the target board via SELECT1, SELECT2 and nSLEEP control lines, PWM input line and nFAULT feedback line. The board is designed to use 3.3V or 5V power supplies. It can be powered either from the mikroBUS socket or externally through CN2 terminals. It is limited to a 0.9A driving current with 0.22O current sense resistor. The motor is connected to CN1 screw terminal.
Specification
| Type | DC |
| Applications | Board is designed as a full H-bridge driver for the DC motor |
| On-board modules | DRV8833RTY H-Bridge motor driver, 74HC4053 multiplexer and two screw terminals |
| Key Features | RED LED indicates active nFAULT line (in case of short-circuit). Full H-bridge driven by a single PWM signal |
| Key Benefits | Can be powered externally through CN2 terminals |
| Interface | PWM,GPIO |
| Input Voltage | 3.3V or 5V |
| Compatibility | mikroBUS |
| Click board size | L (57.15 x 25.4 mm) |
Downloads
Write a review
Your Name:
Your Review:
Note: HTML is not translated!
Rating:
Bad
Good
Enter the code in the box below:
-
₹1,999.00
© 2024, MG Automation Technologies. Powered by MG Super LABS.Find us on Google+
Designed with by Ish Gupta