6 Port AX/MX Power Hub
The 6 Port AX/MX Power Hub is a must have accessory for any DYNAMIXEL user. This little board is a Bioloid 6 Port Hub and a SMPS adaptor all in one!
The DYNAMIXEL communication bus allows you to daisy chain multile servos, making wiring a breeze. However sometimes you need to split your DYNAMIXEL chain into multiple directions. Just plug a 3-Pin Dynamixel Cable from your controller to any port on the hub, and you'll have 5 ports avaialble for DYNAMIXEL servos.
This hub has the added benefit of 2 power breakouts. You can plug in bare wire with the screw terminal block, or plug in power through the DC barrel jack. The 2.1*5.5 female barrel jack will accept any of our SMPS power supplies as well as our Battery Wiring Harness.
The AX/MX Power Hub is compatible with the following DYNAMIXEL servos:
This hub is NOT compatible with the 4-pin RX and EX series of DYNAMIXEL servos.
*Under certain circumstances, these servos can drop the voltage on Switched Mode Power Supplies. If you are using these servos with an SMPS we recommend also using the SMPS2DYNAMIXEL
Enter the code in the box below: