Categories


78:1 Metal Gearmotor 20Dx43L mm 6V CB with Extended Motor Shaft

Product Code: Pololu #3715

78:1 Metal Gearmotor 20Dx43L mm 6V CB with Extended Motor Shaft
78:1 Metal Gearmotor 20Dx43L mm 6V CB with Extended Motor Shaft
78:1 Metal Gearmotor 20Dx43L mm 6V CB with Extended Motor Shaft
78:1 Metal Gearmotor 20Dx43L mm 6V CB with Extended Motor Shaft

₹2,269.00
GST inclusive



Qty:

Availability: Backorder


Add to Wish List



These cylindrical brushed DC gearmotors are available in a wide range of gear ratios, from 25:1 up to 488:1, and with three different motors: 6 V and 12 V motors with long-life carbon brushes (CB), and a 6 V motor with shorter-life precious metal brushes. All three motors offer similar performances at their respective nominal voltages, just with the 12 V motor drawing approximately half the current of the 6 V motor and with the carbon brush versions having longer lifetimes than the one with precious metal brushes.

These gearmotors are optionally available with an additional 2 mm-diameter output shaft that protrudes 6 mm from the rear of the motor. This rear shaft rotates at the same speed as the input to the gearbox and offers a way to add an encoder, such as our magnetic encoder for 20D mm metal gearmotors as shown in the right picture below, to provide motor speed or position feedback.

The gearmotors all have 20 mm diameter gearboxes and 4 mm diameter gearbox output shafts, so it is generally easy to swap one version for another if your design requirements change (though the length of the gearbox tends to increase with the gear ratio).

Specification

Dimensions

Size: 20D × 44.7L mm1
Weight: 45 g
Shaft diameter: 4 mm2

General specifications

Gear ratio: 78.125:1
No-load speed @ 6V: 180 rpm
No-load current @ 6V: 0.15 A
Stall current @ 6V: 2.9 A3
Stall torque @ 6V: 4.4 kg·cm3
Max output power @ 6V: 2.1 W
Extended motor shaft?: Y
Long-life carbon brushes?: Y
Motor type: 2.9A stall @ 6V CB (carbon brush)

Performance at maximum efficiency

Max efficiency @ 6V: 33 %
Speed at max efficiency: 150 rpm
Torque at max efficiency: 0.76 kg·cm
Current at max efficiency: 0.59 A
Output power at max efficiency: 1.2 W

Notes:

  • Not including output shafts; output shafts add 24 mm to the total length.
  • D shaft.
  • Stalling is likely to damage the gearmotor. Stall parameters come from a theoretical extrapolation of performance at loads far from stall. As the motor heats up, as happens as it approaches an actual stall, the stall torque and current decrease.

Related Documents

Write a review
Your Name:


Your Review:
Note: HTML is not translated!
Rating:
Bad           Good

Enter the code in the box below:



© 2024, MG Automation Technologies. Powered by MG Super LABS.Find us on Google+
Designed with by