Atlas Scientific EZO-PMP Advanced Kit at MG Super Labs India

The EZO™ Advanced pump kit comes with everything found in our original EZO pump kit and more!

Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!

*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*

Specification

Enclosure:
Size	Metric: L = 145mm x W = 90.5mm x H = 80mm
	Inch: L = 5.7″ x W = 3.5″ x H = 3.1″
Enclosure protection	IP-64
Enclosure material	Body: Polycarbonate plastic
	Screws: Stainless steel
*Pump:*	*This pump is set to I2C mode by defualt*
	*It can be change to UART mode.*
	*See data sheet for instructions*
Flow rate	0.5ml to 105ml/mins
Accuracy	+/- 1%
Modes of operation	Continuous dispensing Volume dispensing Dose over time mode Constant flow rate Dispense at startup
Connector	5 lead data cable
Calibration	Single point
Supplied tubing	15.24 cm
Tubing size	Any 5mm O.D. tubing
Data protocol	UART & I2C
Default I2C address	103 (0x67)
Operating voltage	3.3V – 5V (logic)
	12V – 24V (motor)
Pump head	2 meters
Data format	ASCII
Food safe	Yes